Journal of Materials Science Research and Reviews

Influence of Burnt Sawdust Ash from Timber Species on the Chemical Strength Properties of Laterite-interlocking Blocks

Assiamah Sampson *

Department of Civil Engineering, School of Engineering, Kwame Nkrumah University of Science and Technology, Kumasii, Ghana.

Charles K. Kankam

Department of Civil Engineering, School of Engineering, Kwame Nkrumah University of Science and Technology, Kumasii, Ghana.

Kwadwo Adinkrah-Appiah

Department of Civil Engineering, Sunyani Technical University, Sunyani, Ghana.

Russell Owusu Afrifa

Department of Civil Engineering, School of Engineering, Kwame Nkrumah University of Science and Technology, Kumasii, Ghana.

Osei Jack Banahene

Department of Civil Engineering, School of Engineering, Kwame Nkrumah University of Science and Technology, Kumasii, Ghana.

Daniel Okai

Department of Civil Engineering, Sunyani Technical University, Sunyani, Ghana.

*Author to whom correspondence should be addressed.

---

Abstract

In the construction industry in Ghana and many other developing countries, blocks are predominantly used for the construction of walls in housing units. Their widespread application has led to the astronomical costs of producing the blocks units with significant environmental challenges as a results of materials like cement, fine aggregates and coarse aggregates. Therefore, an increasing quest globally to find low-cost and environmentally friendly alternative materials to replace cement with burnt sawdust ash (BSDA) from timber species in the manufacturing of compressed laterite interlocking blocks. The main aim of the study was to partially replace ordinary Portland cement (oPc) with burnt sawdust ash (BSDA) from timber species (Wawa-Triplochiton scleroxylon, Mansonia-Altissima, Teak-Tectona grandis, Odum-Milicia excels, Ceiba-Pentandra, Essah-Celtis mildbraedii and Mahogany-Swietenia macrophylla) in making interlocking laterite blocks by replacing 0-30 wt % sawdust ash. Mix proportion was 1:6 (cement + BSDA: laterite) with a 0.50 water-to-cement ratio. Two (2) tests were targeted for the research: Energy Dispersive X-Ray Spectroscopy (EDS) and Scanning Electron Microscopy (SEM) strength. It was observed that, the combined SiO₂, Fe₂O₃ and Al₂O₃ content satisfied the minimum requirement and the SiO₂ (29.5537.38%), Al₂O₃ (10.95-35%) contents were significantly great. it can be concluded that BSDA replacement interlocking laterite blocks have the potential of supporting the affordable housing concept in Ghana.

Keywords: Interlocking blocks, burnt sawdust ash, scanning electron microscopy, energy dispersive X-Ray spectroscopy

---

---

---

References

Joshua O, Lawal P, Cost optimization of sandcrete blocks through partial replacement of sand with lateritic soil, Epistem. Sci. Eng. Technol. 2011;1(2):89–94.

Freestone D. The International Climate Change Legal and Institutional Framework: An Overview. In D. Freestone & C. Streck (Eds.), LEGAL ASPECTS OF CARBON TRADING, UNSW Law Research Paper No. 2011;2009.

Assiamah S, Agyeman S, Adinkrah-Appiah K, Danso H. Utilization of sawdust ash as cement replacement for landcrete interlocking blocks production and mortarless construction. Case Studies in Construction Materials. 2022;16. Available:https://doi.org/10.1016/j.cscm.2022.e00945.

Andohful KF, Mensah CE, Bamfo-Agyei. Understanding the Compressive Strength of Commercially Produced Sandcrete Blocks Using the Ghana Building Code. African Journal of Applied Research. 2021; 7(2):155–175

Available:https://doi.org/ 10.26437/ajar.10.2021.11

Baiden BK, Tuuli MM. Impact of quality control practices in sandcrete blocks production, J. Archit. Eng. 2004;10(2):53–60, Available:https://doi.org/10.1061/ (ASCE) 1076-0431(2004)10

Kareem MA, Raheem AA, Oriola KO, Abdulwahab R. A review on application of oil palm shell as aggregate in concrete-Towards realising a pollution-free environment and sustainable concrete. Environmental Challenges. 2022;8: 100531.

Khan K, Amin MN, Usman M, Imran M, Al-Faiad MA, Shalabi FI. Effect of fineness and heat treatment on the pozzolanic activity of natural volcanic ash for its utilization as supplementary cementitious materials. Crystals. 2022;12(2):302.

Raheem AA. Ige AI. Chemical composition and physicomechanical characteristics of sawdust ash blended cement, J. Build. Eng. 2019;21: 404–408. Available:https://doi.org/10.1016/j.jobe.2018.10.014.

Adetoro EA, Oladapo SA. Effects of Sawdust and Palm Kernel Shell Ashes on Geotechnical Properties of Emure / Ise-orun Local Government Areas Soil, Nigeria. Scientific Research Journal. 2015; III(VII). Available:www.scirj.org

Awolusi TF, Oguntayo DO, Babalola OE, Oke OL, Akinkurolere OO. Investigation of micronized laterite sandcrete block compressive strength, Case Stud. Constr. Mater. 2021;14.

Available:https://doi.org/10.1016/J.CSCM.2021.E00530.

Sojobi AO. Evaluation of the performance of eco-friendly lightweight interlocking concrete paving units incorporating sawdust wastes and laterite. Cogent Engineering. 2016;3(1):1–27.

Available:https://doi.org/10.1080/23311916.2016.1255168

Nasly MA, Yassin AAM. Sustainable Housing Using an Innovative Interlocking Block Building System, in Proceedings of the Fifth National Conference on Civil Engineering (AWAM ’09), Kuala Lu

Shetty MS, Jain AK. Concrete Technology (Theory and Practice), 8e. S. Chand Publishing; 2019.

Raheem AA, Falola OO, Adeyeye KJ. Production and testing of lateritic interlocking blocks. Journal of Construction in Developing Countries. 2012;17(1):35–50.

ASTM International; 2016, Available:https://doi.org/10.1520/C0090-16A

Bediako M. Pozzolanic potentials and hydration behavior of ground waste clay brick obtained from clamp-firing technology, Case Stud. Constr. Mater. 2018; 8:1–7. Available:https://doi.org/10.1016/j.cscm.2017.11.003.

Hannesson G, Kuder K, Shogren R, Lehman D. The influence of high volume of fly ash and slag on the compressive strength of self-consolidating concrete. Construction and Building Materials. 2012;30:161–168.

Available:https://doi.org/10.1016/j.conbuildmat.2011.11.046

Oyebisi S, Olutoge FA, Ofuyatan OM, Abioye AA. Effect of corncob ash blended cement on the properties of lateritic interlocking blocks, Prog. Ind. Ecol. 2017;11(4):373–387. Available:https://doi.org/10.1504/PIE.2017.092729.

ASTM D6913/D6913M-17, Standard Test Methods for Particle-Size Distribution (Gradation) of Soils Using Sieve Analysis, ASTM International; 2017. Available:https://doi.org/10.1520/D6913_D6913M-17.

ASTM C618-1991, Standard Specification for Coal Fly Ash and Raw or Calcined Natural Pozzolan for Use in Concrete, ASTM International; 2019. Available:https://doi.org/10.1520/C0618-19.

BS 1377-9: Method of test for soils for civil engineering. The British Standard; 1990.